Office chair installation steps and methods

Office chair installation steps and methods

First, the first step is to insert the wheel into the five-star foot, and use a little force when inserting it;

After the wheels are installed, turn the five-star foot over, put the air rod into the middle hole, and remove the air rod cap before putting it (if there is a three-section sleeve in the air rod);

Place the seat cushion on a clean ground to install the chassis, pay attention to the direction of the chassis when installing, and tighten the screws;

After the chassis is installed, put the cushion on the air rod and insert it into the hole of the chassis;

After the cushion deflation rod is up, start to install the armrests (note the front, rear, left, and right of the armrest);

Be careful not to tighten all the screws of the armrest, so that the backrest can be installed more conveniently;

Place the backrest on the cushion and pay attention to the direction. First align the backrest with the holes of the armrest, then install the screws on both sides of the bottom of the backrest. After installing the bottom screws, lift the backrest to install the top screws and tighten all the screws;

After tightening all the screws, the armrest decorative buckle is installed, so that a complete chair is installed.